metal roof installation for Red Wing homes, handled by a family roofing company that has been at it since 2002. Estimates are always free.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Red Wing install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Our metal roof installation work in Red Wing is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Red Wing metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
The order we work in, and why each step matters more than it looks.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
What comes up on just about every estimate for a job like this.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Red Wing homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
A straightforward Red Wing house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Most Red Wing metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Installed properly over sound decking, a metal roof should give a Red Wing home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
Honest words from customers, in their own wording.
"The skylight had leaked for two years and three different people had caulked it. These folks reflashed it properly and that was the end of it."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Cannot say enough about how careful they were around the flower beds. Everything got covered and nothing was trampled."